Lanner LEC-2260 Manual do Utilizador descarregar pdf (Página 19)

Hardware Setup

Chapter 4

Embedded and Industrial Computing

Installing the Hard Disk

The system can accommodate one Serial-ATA disks. Follow

these steps to install a hard disk into the LEC-2260:

Take off the HDD tray from the chassis cover.1.

Secure the hard disk with 4 mounting screws on the 2.

HDD tray.

Place hard disk back on the system and align the holes 3.

of the hard disk with the mounting holes of the chassis

cover.

Connect the Serial-ATA power and data cables to the 4.

hard disk’s connectors.

Plug the Serial-ATA cables (power and data) to the 5.

Serial-ATA Connectors on the main board.

Installing the CompactFlash Card

LEC-2260 provides one CompactFlash slot. Follow the

procedures bellow for installing a CompactFlash card.

Take off the front panel first by unscrewing the 1.

case screws and the connector’s hex cap screws as

illustrated below.

Align CompactFlash card and the card slot with the 2.

arrow pointing toward the connector.

Push the card to insert into the connector.3.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 29 30

Sem comentários

Lanner LEC-2260 Manual do Utilizador Página 19